High Data Rate Modulation of High Power 1060-nm DBR Tapered Lasers With Separate Contacts

P. Adamiec1, A. Consoli1, J.M.G. Tijero1, S. Aguilera1, I. Esquivias1, S. Schwertfeger2, A. Klehr2, H. Wenzel2, B. Sumpf2, and G. Erbert2

Published in:

IEEE Photonics Technol. Lett., vol. 25, no. 22, pp. 2171-2173 (2013).

© Copyright 2013 IEEE - All Rights Reserved. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

Abstract:

Direct optical modulation at 2.5 Gb/s with amplitude of more than 0.5 W has been demonstrated in single longitudinal mode distributed Bragg reflector tapered lasers emitting at 1060 nm with separated injection of the ridge waveguide and tapered sections. The modulating signal of ∼110 mA peak to peak was applied to the ridge waveguide section, yielding a high modulation efficiency of ∼5 W/A. The large-signal frequency response of the experimental set-up was limited by the bandwidth of the electrical amplifier rather than by the internal dynamics of the laser, indicating that higher bit rates could be achieved with improved driving electronics.

1 Universidad Politécnica de Madrid, ETSI Telecomunicación-CEMDATIC, Madrid 28040, Spain
2 Ferdinand-Braun-Institut, Leibniz-Institut für Höchstfrequenztechnik, Gustav-Kirchhoff-Straße 4, D-12489 Berlin, Germany

Index Terms:

High brightness semiconductor lasers, direct modulation, multi-contact lasers.